Universal 400 Tamper POM CR 400 pins + Base
REF: TAS400CR-***
──────────────────────────────────────────
CAPSULE SIZES AVAILABLE: ***000/00 - 0/1/2 - 3/4
Capsules available at Feton.
──────────────────────────────────────────
COMPOSITION OF THIS KIT:
CAPSULE FILLER UNIVERSAL400 - INFORMATIONS
- Capsule filler to fill 400 capsules in one go.
HOW TO USE
1. Prepare your material: choose the right set of plates for the capsule size you are using. Install the plates in this order: Spacer plate, Bottom Plate, Filling Plate,
Top Plate.
2. If you have a capsule Loader, please refer to the Loader datasheet for instructions. If you do not have a capsule Loader, place the capsules into the Top
Plate one by one or with our Feton Cards.
3. Pull the Lever to lock the capsules’ bodies.
4. Pull the Top Plate upwards, starting from the front side for easier separation.
5. Release the Lever. If needed, push on the capsules’ bodies so that they are flush with the Filling Plate.
6. Fill the capsules with your preparation.
7. If needed, you can use a Tamper400 to push the powder into the capsules to be able to fill a higher volume.
8. Place the Top Plate with the locked lid. Pull up the Base Plate to push the capsules’ bodies into the capsules’ heads. The capsules are now “pre-closed”.
9. Take the Top Plate with the locked lid and turn it upside down on your table. If you have a Serial Closer, use it to close the capsules in one motion. If not, close the capsules by hand.
10. Open the lid and push the capsules out of the
BENEFIT :
• One single frame for all capsule sizes.
• Only metallic plates and frame.
• Fill capsule sizes 4, 3, 2, 1, 0, 00 and 000.
• No adjustment necessary.
• 400 capsules at a time.
• Extra space to fill the capsules.
• Very robust design.
• Easy to clean.
DIMENSIONS AND WEIGHT:
Dimensions:
Length: 410 - 470 mm
width: 410 mm
height: 90 mm
Weight:
From 19 kg (size 000) to 20,5 kg (size 4)
TIPS:
Universal400 : Starter kit
Find our accessories.
HOW TO CLEAN:
It is important to clean the parts in contact with the capsules or the powder thoroughly between each use to avoid contamination. Cleaning can be done by hand, in a dishwasher or in an autoclave. If done by hand, use warm water and soap.
Use a maximum temperature of 110°C / 230°F for all the metallic parts.
Use a maximum temperature of 40°C / 104°F for all the plastic parts.
If you have difficulties washing the inside of holes on the plates, use the Feton-cleaning brush.
For information - Note for Anodised Aluminium parts :
If done in a dishwasher or in an autoclave, do not use alkaline or acid cleaning product that are not suitable for treated aluminium (nickeled or anodized), as they
oxidize the surface treatment of the plates which could deteriorate or change color.
Example of unsuitables products :
- Base : Alkaline detergent
- For anodized parts not suitable for ph > 7
- Acids : Hydrogen peroxide
- For anodized parts not suitable for ph < 4
In general, use cleaning products whose ph is neutral.
Please refer to the technical datasheet of your cleaning product to check
whether it is suitable or not.
NOTE : Just because the surface treatment has changed color slightly does not
mean the plate is eligible for a return under warranty.
──────────────────────────────────────────
ORDER NOW :
contact@feton.com order via our contact form.
With a dynamic R&D department, we are ready to fulfill your special requests.
